Content

  • eC-workshop – high speed design
  • eC-workshop – KiCAD

April 4 – 2017 – eC-workshop – high speed design.

 

Creating complex layouts with modern EDA-tools is a lot easier than it has been in the past. However there are still challenges one has to face when using state of the art technology. Especially hi-speed designs that make use of DDR2/3-RAM and fast serial interfaces like LVDS and hi-speed USB may pose a challenge.

This workshops deals with the issues that arise when creating layouts for such hi-speed designs. One needs to consider suitable multilayer-stackups as well as controlled impedance and signal propagation delay.

There are a lot of tools available to help with these issues, but most of these tools are quite expensive. In this workshop we will examine how to create sophisticated hi-speed layouts using EAGLE and tools that are either open-source of free of charge.

More on this eC-workshop here!

For participant convenience and to ensure the best possible quality of the workshop, we limit the number of participants per session to 10. Register for this seminar via this link.

April 5 – 2017 – eC-workshop – KiCAD.

 

KiCAD is a free & open-source software suite for EDA. For a while now the layout engine of KiCAD has been more powerful than similar layout engines of some commercial EDA suites.

KiCAD is available for Windows, OSX and Linux – in binary and source code.

This workshop covers schematics capture and layouts using KiCAD.

More on this eC-workshop here!

For participant convenience and to ensure the best possible quality of the workshop, we limit the number of participants per session to 10. Register for this seminar via this link

We hope to welcome you in our factory Eurocircuits Aachen in Baesweiler – Germany.

Kind regards,

Christof Vercouter

Christof.vercouter@eurocircuits.com