These Guidelines set out best practice to reduce the cost of your boards and to minimize the risk of errors arising during manufacture. Not all possible PCB design features are available on all our services. Look at our services overview to see more details. On some specific features we highlight the availability in a particular service.
The world is divided into a part that works with the Metric system and a part that works with the Imperial system for defining measurements. The “μm” is 25.4 times smaller than the “Mil”. Dimensions for electronics are driven smaller all the time. To ensure the highest quality possible, we decided many years ago to work exclusively in the Metric system in our front end department. Therefore the basis of all measurements given in this document and in our website is the Metric system. All Imperial values are there for clarification and general understanding only.
There is no general consensus throughout the global PCB industry on terminology, so if we feel any term we use may be unclear we have tried to explain it when it first appears.

What you can expect in this document:
- Data formats accepted by Eurocircuits for production of your PCB prototypes and small series
- Requirements for design data to comply with the Eurocircuits specifications to allow a smooth production of your PCB prototype
- PCB classification table, for both pattern classification and drill classification . The classification of your PCB prototype has a major influence on the price as well as on the manufacturability of your PCB prototype or small batch.
- Guidelines for Drills ( PTH as well as NPTH)
- Design guidelines for the copper pattern.
- Design guidelines for the mechanical layers ( contours, slots, etc ).
- Design guidelines for generation of soldermask, legend, carbon pads, peel-off mask, via fill, and heatsink paste.

...read more...(PDF 2.61 Mb)